Weber mt MC 85 - Messages on the Radio Remote Control

30
6.5. Messages on the radio remote control
Message Cause Response of the machine Remedy
Near-eld
shutdown system
was tripped
Driving and steering
commands are stopped
Remove the machine
from the safety area
OR
drive in the opposite
direction
The remote
shutdown system
was tripped
Driving and steering
commands are stopped
Step closer to the machine
Radio connection
disrupted
Driving and steering
commands are stopped.
Theengineisswitchedo󰀨.
Find the cause of why the
radio connection was lost.
If necessary, refer to the
“Maintenance”section
for assistance
Vibration lever,
drive lever or
steering level is not
in the zero position
Unable to start
Move all levers to
the neutral position
Engine oil pressure
too low
Engineisswitchedo󰀨
Check engine oil, see
section“Maintenance”
Coolant
temperature is
too high
The engine is switched to
a safe mode 30 seconds
after the error is reported.
It now only operates
at idle speed.
Allow the engine to cool
down at idle speed.
Check the coolant level
if necessary, see section
“Maintenance”.
Machine operates
at rapid motion
speed
--- ---