Weber mt MC 85 - Operation

23
5.6. Operation
When traveling at operating speed (up to 1.7 km/h), the machine
can drive, steer and vibrate.
WARNING
Risk of injury for unauthorized persons in the danger area!
Thenear-eldshutdownsystemprovidesprotectiononlyto
the operator, not to third parties!
Driving at operating
speed
SelectECOmodeusingthe“Enginespeed”selectorswitch.
Move the machine using driving and steering commands.
Activate the vibration as needed.
Driving at rapid motion
SelectECOmodeusingthe“Enginespeed”selectorswitch.
Move the machine using driving and steering commands.
Pressoneofthetwo“Rapidmotion”pushbuttonsaswell.
When traveling at rapid motion (up to 3.1 km/h), the machine
can drive and steer.
Rapid motion is not available with the vibration switched on.
Slow maneuvering To allow for precise maneuvering, the machine can also drive with
the engine running at idle speed.
The vibration is not available in idle speed mode.
Selectidlespeedusingthe“Enginespeed”selectorswitch.
Move the machine using driving and steering commands.
WARNING
The directional information on the remote control only applies if
the operator is located behind the machine. If the operator changes
their position, the directional information may change as well.
There is risk of severe injury when becoming crushed between
the machine and other objects or walls.
Become familiar with the control.
Observethesection“Positionoftheoperator”.
Stay behind the machine during operation whenever possible.
Be aware of your surroundings.
Always ensure that everyone keeps at a safety distance of at
least 2 meters around the machine.
Sound the horn if necessary.
Do not resume operation until everyone has left the danger area.