Weber mt MC 85 - 6 Notices on Operation; Position of the Operator

25
B 1006-0120
20 m
2 m
6. Notices on operation
6.1. Position of
the operator
The switches on the radio remote control are arranged in such
a way that they map the movements of the machine when the
operator is positioned behind the machine.
This means, for instance, that the machine will move away from
theoperatorwhenthedriveleverisdeectedtothefront.When
thesteeringleverisdeectedtotheright,themachinewillmoveto
the right. The directional information only applies if the operator is
positioned behind the machine.
If changing their position, the operator must keep in mind that the
directional information of the control levers will no longer match
the travel direction of the machine.
If the operator stands in front of the machine, the machine will move
in the opposite direction of the driving and steering commands given.
If, for instance, the machine moves toward the operator, the drive
leverisdeectedtothefront.Whenthesteeringleverisdeectedto
the left, the machine will move to the right, as viewed by the operator.
Do not use rapid motion unless the operator is positioned behind
the machine.
WARNING
Risk of injury for unauthorized persons in the danger area!
Thenear-eldshutdownsystemprovidesprotectiononlyto
the operator, not to third parties!
Always ensure that everyone keeps at a safety distance of
at least 2 meters around the machine.
Alert everyone in the vicinity of the machine of the danger.
Sound the horn if necessary.
Do not resume operation until everyone has left the danger area.