Weber mt MC 85 - Page 12

12
Maintenance The roller must be inspected in accordance with the corresponding
implementation conditions and operating conditions to ensure its
operationally safe status. This inspection should be performed as
needed by an expert – however, no less than once a year or every
150operatinghours.Thendingsoftheinspectionmustbestored
in writing until the time of the next inspection.
Maintenance and repairs must not be performed unless all drives
are at a standstill and the articulated joint has been secured.
Deviations from this precaution are not permissible unless
warranted for the completion of the work. The roller must be
secured against rolling away before work commences.
Prior to work on unsecured parts of the electrical system,
the combustion engine must be safeguarded against unintentional
start. This requires that the electrical connection to the battery or
the starter be interrupted.
Following the conclusion of all maintenance and repairs, all protective
xturesmustberettedandplacedbackintooperation.
Dischargedoperatinguidsmustbecollectedandstoredinsuitable
containers. Disposal in accordance with environmental protection
regulations.
Useclearwaterforcleaning.Donotuseammablesolvents.
The vapors of the solvents may ignite upon contact with hot
components or other sparks.
The radiator cover cap may only be opened when the radiator
is cold. Hot coolant is pressurized. Opening the radiator while it
is still hot can lead to severe burns.
Before starting the machine after maintenance operations,
make sure that all loose parts (screws, tool, etc.) have been
removed from the machine. They be drawn in by moving parts.
The entire machine must be kept clean. The stickers must always
be clearly legible. Damaged stickers must be replaced.
Cleaning work
Cleaning with a high-pressure cleaner is only allowed in the bottom
section of the machine. The top section of the machine must be
cleaned with a weaker jet of water.
To prevent environmental pollution, cleaning tasks may only be
executed in areas that are suitable and have been approved for
this purpose (e.g. drain with oil separator).