Weber mt MC 85 - Page 40

40
8
4
6
5
7
Check the hydraulic oil level using the view
glass (4).
Thelllevelmustbeat¾oftheviewglass.
If this is not the case, proceed as described
in section 10.2.10.
The coolant level can be checked through
the slightly transparent expansion
reservoir (5).
The coolant level must range between the
two markings (6). If this is not the case,
topo󰀨thecoolantfollowingthespecications
in the table included in section 10.3.
Openthecap(8)andtopo󰀨thecoolant.
Close the cap (8).
Also check the level of the coolant in the
radiator(7).Itmustbelledupalltheway.
The tank is pressurized. Risk of scalding due to
hot coolant.
WARNING
Do not open the cap unless the radiator
is cold!