WEG CFW-11 RB - Access to the Control and Power Terminal Strips

3
Installation and Connection
CFW-11 RB | 3-9
3.1.5 Access to the Control and Power Terminal Strips
Frame Size E:
It is necessary to remove the keypad (HMI) and the control rack cover in order to get access to the control terminal
strip (see Figure 3.7 on page 3-9). In order to get access to the power terminal strip, remove the bottom front
cover (see Figure 3.8 on page 3-9).
1 2 3
Figure 3.7: HMI and control rack cover removal - frame size E
1 2
Figure 3.8: Bottom front cover removal - frame size E