www.wegener.com 800092-01 Rev. A 49
Unity 552 User’s Manual
Following is a list of commands along with synopsis. A general syntax for the group
command is:
Table Apx 1.2: Diagterm Individual Commands
Command Synopsis
abortrec Tune to Last Successful (S) or Last commanded (C)
abort Abort Temporary Insert
adds Add Location Settings
ap Audio Program
ap2 Audio Program 2
audatten Audio Attenuation
audroute Set Audio Routing (S-Stereo; 1 or 2 Left/Right; R-Reverse
Stereo)
contentaccess Set access level for content on HDD (Read-only or Full)
dels Delete Location Settings
errors Set Alarm Threshold
ifconfig Display current ETHERNET device(s) configuration
lnbpwr Turn LNB Power ON/OFF
lnbselect Set LNB Mode UNIV/ASTRA or STD/LO
margin Set margin offset (Range: 1.0 - 10.5 dB)
movep Move Preset entry (source and destination entry #'s)
permch Set perm settings from search table (Position: 1-48)
perm Set Perm Settings
port Select RBDS port
re Turn solid-state Relays On or Off
savep Save current Settings to a Preset entry
Service Enable or Disable named service
setlnb Set LNB LO Frequency
settimeout Set Timeout (Source #2-5 and time)
set Set Individual Carrier Parameters
snr Set SNR margin offset
To Next Page
Loading...
