上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
111 / 144
Forward/Retract Speed
Speed during moving forward/backward.
Range: [10, Maximum value of maximum speed between X-axis and Y-axis]mm/min
Default value: 3000
5.4.5 Leap Frog
Enable Frog Leaping
Whether to enable leapfrog.
It is modified synchronously with frogleap function in Layer Setting dialog box. See
Layer Function for details.
Default value: Yes
Leaping Min. Dis
When the distance between the start point and the end point is smaller than this
value, Z-axis jumps to the machining point instead of executing leapfrog.
Range: [0.01, 100]mm
Default value: 10
5.4.6 Scan Cutting
Scan Type
Used to change the terminal board during scan cutting.
1: 1st generation-LD5S
2: 2nd generation-LD5E
Default value: 1
Wiring of S Port of Terminal Board
Used to select the wiring type of port S of the terminal board.
0: COM
1: 24V
Default value: 1
Laser on Lead Time for Scan Cutting
It can be set larger when some workpiece is left uncut at trace start.
Range: [0, 10]
Default value: 2
To Next Page
Loading...
