上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
44 / 144
Set value: set it according to PG divider ratio (Weihong system).
P2-10 Digital Input Pin 1 (DI1)
Format: X2X1X0
X1X0=01: digital input (DI1 = SON) corresponds to 9th pin of CN1.
X2=1: set DI1 input as NO (normally open) a-contact point.
Set value: 101
P2-15 Function Setting for Digital Input Pin DI6
Default factory setting of DI6 and DI7 is NC (normally closed) limit signal input.
Drive cannot run without being connected to pin 32 and pin 31 of CN1.
Format: X2X1X0
X2=1: set DI6 and DI7 input as NO a-contact points.
X1X0=00: limit input of drive is not used.
Set value: 100
P2-16 Function Setting for Digital Input Pin DI7
Format: X2X1X0
Set value: 100
P2-17 Function Setting for Digital Input Pin DI8
Format: X2X1X0
X2X1X0=100: external EMG stop input is not used.
Set value: 100
P2-21 Function Setting for Digital Output Pin DO4
DO4 corresponds to pin 1 & pin 26, used as clamping-position brake signal of Z-axis.
Format: X2X1X0
X2=1: set DO4 output as NO (normally open) a-contact point.
X2=0: set DO4 output as NC (normally closed) b-contact point.
X1X0=08: set pin 1 and pin 26 as BK+ and BK- respectively.
Set value: 108
To Next Page
Loading...
