上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
79 / 144
Default value: 100
Max Plugging Depth
Maximum allowable plugging depth of the cutting head relative to the workpiece
surface.
If the actual plugging depth exceeds the set value of the parameter, the cutting head
will be outside the workpiece and it will be lifted.
Range: [0, 5]mm
Default value: 0
Reference Height in Margin
If current capacitance stays smaller than the capacitance corresponding to the value
of this parameter during sense delay, the system considers the cutting head within
the workpiece margin and automatically opens follow-up.
Range: [0, 5]mm
Default value: 0
Sense Delay in Margin
Needed delay time for detecting whether the cutting head is within the workpiece
margin.
A too large large value leads to lag during following and a too small value leads to
too sensitive response.
Range: [1, 500]ms
Default value: 10
Reference Height Out Margin
If current capacitance stays larger than the capacitance corresponding to the value
of this parameter during sense delay, the system considers the cutting head beyond
the workpiece margin and closes follow-up.
Range: [Reference height in margin, 20]mm
Default value: 5
Sense Delay Out Margin
Needed delay time for detecting whether the cutting head is beyond the workpiece
margin.
A too large value will cause that the cutting head detects the margin intensitively
and plugs too deep.
Range: [1, 500]ms
To Next Page
Loading...
