上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
78 / 144
Out Margin Sensitivity
The larger the value is, the higher the tendency is to judge whether the cutting head
is beyond the workpiece margin.
The larger the value is, the higher the tendency for judging out margin is.
Range: [1, 10]
Default value: 5
4.3.5 Speed Setting Parameters
Z-axis G00 Speed
Speed of the cutting head during moving up and down.
A too large value needs calibration length added accordingly for the cutting head to
slow down, so as to avoid colliding with the workpiece.
Range: [0, maximum speed of Z-axis]mm/min
Default value: 15000
Max Speed in Follow
Maximum speed during following.
Range: [0, maximum speed of Z-axis]mm/min
Default value: 20000
Max Speed Supported by Z
Maximum value of following speed and G00 speed.
Range: [60, 3932100]mm/min
Default value: 20000
Follow Acceleration
Acceleration during following.
Default value: 10000mm/ s
2
4.3.6 Follow-up Outside Workpiece Parameters
Max Kp in Follow Outside Part
Follow outside workpiece is used to avoid following too fast and plunging too deep.
Used to limit Kp value.
During outside workpiece following, Kp value is limited within this parameter
range.
Range: [0, 65535]
To Next Page
Loading...
