上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
77 / 144
Calibrate Curve Smoothing Point No.
Used to set the number of calibrated points for the calibration curve.
Range: [0, 500]
Default value: 0
4.3.3 Follow Setting Parameters
Z Up Position
After returning to the machine origin, the machine coordinate of Z-axis up position
after following is turned off or cutting finishes.
Default value: -10
Safety Height
Safety height to lift Z-aixs before returning to the machine origin.
Range: [0, 100]mm
Default value: 10
Follow Height
The relative distance between the cutting head and the workpiece under follow-up
control.
Range: [0, 30]mm
Default value: 1
4.3.4 Real-time State Check Parameters
Out Margin Check
Whether to check the cutting head moving beyond the workpiece margin during
following.
If the cutting head moves beyond the workpiece margin, it will stop.
Default value: Yes
Out Margin Tolerance
Compared with the follow-up height position, if the current position is beyond
tolerance range, the system will consider the cutting head is beyond the workpiece
margin.
Range: [0, 20]mm
Default value: 2
To Next Page
Loading...
