Manual R06-2016 65 / 172
ROTARY INDEXING TABLE CONTROLLER
EF2...B
INSTALLATION | 6.2 Power Module PM240-2; frame size FSA / FSB
6.2.5.1 Permissible motors
Motors should be used for converter operation or with greater isolation.
• Motors for 200-V-Power Modules
Asynchronous motor in the range of 25 % … 150 % of the converter output are permissible without restrictions
for 200-V-Power Modules.
• Motors for 400-V-Power Modules
Asynchronous motor in the range of 25 % … 150 % of the converter output are permissible without restrictions
for 400-V-Power Modules.
6.2.5.2 Motor connection PM240-2, frame size FSA
The plug connections are located on the bottom side of the power module.
Fig. 37: Motor connection PM240-2, frame size FSA
Name
Motor connection plug
Release lever
U2 Motor phase U
V2 Motor phase V
W2 Motor phase W
Protective ground
Screw terminals
Cross-section
Tightening torque
Stripping length
1.5 to 2.5 mm
2
0.5 mm
8.0 mm
Motor terminal block with star bridge Motor terminal block with delta bridge
For terminal identifications refer to terminal block lid
U1
V1
W1
U1
V1
W1
To Next Page
Loading...
Need help?
General
