Whistler WS1040 User Manual

38
LMIT Menu Reference
Scan Lists – Press SEL to assign the object to scan
lists. An asterisk (*) indicates an assigned scan list.
FrLo – Lowest frequency in the range.
FrHi – Highest frequency in the range.
Tag – The display name for the object.
L/Out – Permanent lockout status for the object.
LED Mode – Solid or Flash.
LED Color – 0=Off, 1=Red, 2=Yellow, 3=Green,
4=Cyan, 5=Blue, 6=Magenta, 7=White.
Latch LED – Off, the Alert LED is on only during a
transmission; On, the Alert LED remains lit after a
transmission, unless overridden.
Backlight – On, Off, or Flash.
Alarm – None, Chirp, Hi-Lo, Alert, Ring, 2-Chirp,
Fast Hi-Lo, DTMF#.
Fav – Assigns the object to the Favorites scan list.
Modulation – Automatic, AM, FM, or NFM
Atten – Attenuation. On or Off.
Delay – On or off.
Delay Time – (1-250) Delay time in 100 ms.
Zeromatic – On or off.
Search Dir – Up or Down.
Hit Count – Number of received transmissions for
the object. Global Hit Counts must be set to on.
Press the Dflt softkey to reset to 0.
LIMIT SEARCH

Whistler WS1040 Specifications

General

Channels	1800
Display	LCD
Power Source	AA batteries or AC adapter
CTCSS/DCS	Yes
Trunking	Motorola, EDACS, LTR
Close Call RF Capture	Yes
Priority Scan	Yes
Weather Alert	YES
Type	Handheld
Digital Modes	P25 Phase I
Modulation Modes	AM, FM
PC Connectivity	Yes
Frequency Coverage	25-54 MHz, 108-174 MHz, 216-512 MHz, 764-960 MHz, 1240-1300 MHz