41
Spectrum Sweeper Object (SWPR)
Spectrum Sweeper can find distant or weaker signals.
With default settings, the SWPR object will sweep
through important land mobile radio bands. As you
become more familiar with SWPR operation, you can
specify bands to improve your search.
Because a SWPR object is assigned to a scan list, it can
be used to search while the radio is scanning. It can
also be used as a stand-alone search.
To create a new SWPR object:
1. Press PGM.
2. Press the NEW softkey.
3. Press the SRCH softkey.
4. Press the SWPR softkey.
5. Configure settings for the object. To restore the
default setting, press the Dflt softkey.
6. Name your search in the Tag field.
7. To search while scanning, assign the object to a
scan list.
8. Press the Save softkey.
To begin a Spectrum Sweeper search:
1. Press MAN.
2. Use the 4-direction keypad to navigate to the
SWPR object.
3. Press the SWPR softkey (not the SRCH key on the
keypad).
4. Press the PSE key to hold on a transmission. To
resume, press the PSE key again.
• Press the FrL/O softkey lock out a frequency.
• Press the STOR softkey to create a new CONV
object using the found frequency.
Change
Setting
Scroll
SPECTRUM SWEEPER
To Next Page
Loading...
Need help?
General
