Whistler WS1040 User Manual

37
Limit Search Object (LMIT)
Because a LMIT object is assigned to a scan list, it can
be used to search while the radio is scanning. It can
also be used as a stand-alone search.
To create a new LMIT object:
1. Press PGM.
2. Press the NEW softkey.
3. Press the SRCH softkey.
4. Press the LMIT softkey.
5. Configure settings for the object. To restore the
default setting, press the Dflt softkey. Enter the
beginning ( FrLo) frequency then enter the ending
(FrHi) frequency.
6. Name your search in the Tag field.
7. To search while scanning, assign the object to a
scan list.
8. Press the Save softkey.
To begin a Limit search:
1. Press MAN.
2. Use the 4-direction keypad to navigate to the LMIT
object.
3. Press the SRCH softkey (not SRCH on the keypad).
4. Press PSE to hold on a transmission. To resume,
press PSE again.
• Press the FrL/O softkey lock out a frequency.
• Press the STOR softkey to create a new CONV
object using the found frequency.
Change
Setting
Scroll
LIMIT SEARCH

Whistler WS1040 Specifications

General

Channels	1800
Display	LCD
Power Source	AA batteries or AC adapter
CTCSS/DCS	Yes
Trunking	Motorola, EDACS, LTR
Close Call RF Capture	Yes
Priority Scan	Yes
Weather Alert	YES
Type	Handheld
Digital Modes	P25 Phase I
Modulation Modes	AM, FM
PC Connectivity	Yes
Frequency Coverage	25-54 MHz, 108-174 MHz, 216-512 MHz, 764-960 MHz, 1240-1300 MHz