Whistler WS1040 User Manual

51
Initializing Global Settings
You can reset the global radio parameters to their
factory state without losing information stored in the
scanner’s working memory. However, any changes to
the radio’ s global settings will be lost.
NOTE: V-Scanner memory is not affected by this
operation.
To initialize Global settings:
1. Turn off the scanner, then turn it on again.
2. When the Welcome/Owner screen appears press
0. The scanner displays:
3. Press 2. The scanner displays:
4. Press ENT. The scanner displays:
5. Press any key to proceed. The scanner reboots
with default global parameters.
System Tests:
Select a Test...
Exits if no key
is pressed
Init GLOB data
To factory state
ENTER if APPROVE
CLEAR to EXIT
GLOB EEPROM area
Initialized to defaults.
Press any key.
INITIALIZING GLOBAL SETTINGS

Whistler WS1040 Specifications

General

Channels	1800
Display	LCD
Power Source	AA batteries or AC adapter
CTCSS/DCS	Yes
Trunking	Motorola, EDACS, LTR
Close Call RF Capture	Yes
Priority Scan	Yes
Weather Alert	YES
Type	Handheld
Digital Modes	P25 Phase I
Modulation Modes	AM, FM
PC Connectivity	Yes
Frequency Coverage	25-54 MHz, 108-174 MHz, 216-512 MHz, 764-960 MHz, 1240-1300 MHz