en Commissioning
90 WILO SE 2018-12
Current switching state of the float switch
Switchgear running time
The time* is stated depending on the unit, in minutes (min), hours
(h) or days (d).
Running time: Pump1
The time* is stated depending on the unit in minutes (min), hours (h)
or days (d). The display varies, depending on the timespan:
▪1 hour: Display in 0 … 59 minutes, unit: min
▪2 hours to 24 hours: Display in hours and minutes, separated by a
decimal point, e.g. 10.59, unit: h
▪2 days to 999 days: Display in days and hours, separated by a
decimal point, e.g. 123.7, unit: d
▪From 1000 days: Display in days, unit: d
Running time: Pump2
The time* is stated depending on the unit in minutes (min), hours (h)
or days (d).
Running time: Pump3
The time* is stated depending on the unit in minutes (min), hours (h)
or days (d).
Switchgear switching cycle
Switching cycles: Pump 1
Switching cycles: Pump 2
Switching cycles: Pump 3
Serial number
Display switches between the 1st and 2nd four digits.
Switchgear type
Software version
Set value for the motor current monitoring value: Pump1
max. rated current in A
Set value for the motor current monitoring value: Pump 2
max. rated current in A
Set value for the motor current monitoring value: Pump 3
max. rated current in A
Current rated current of pump 1 in A
display changes between L1, L2 and L3
press and hold the operating button. The pump starts after 2s of
pumping operation until the operating button is released.
Current rated current in A for pump 2
display changes between L1, L2 and L3
press and hold the operating button. The pump starts after 2s of
pumping operation until the operating button is released.
To Next Page
Loading...
