WinGD X92-B - Page 15

6-3 iGPR - schematic diagram .......................................................................... 214
6-4 LDU-20 - overview ....................................................................................... 218
6-5 LDU-20 color display - general items .......................................................... 219
6-6 iELBA Control .............................................................................................. 220
6-7 MCP page - MAIN locked ............................................................................ 223
6-8 MCP page - MAIN ....................................................................................... 226
6-9 MCP page - Open user parameters ............................................................ 228
6-10 MCP page - Select user parameter ............................................................. 229
6-11 MCP page - Adjust user parameter ............................................................. 230
6-12 MCP page - SYSTEM INFO ........................................................................ 232
6-13 MCP page - TREND .................................................................................... 234
6-14 MCP page - INSTRUMENTS ...................................................................... 236
6-15 MCP page - FUEL / LUBRICATION SYSTEM ............................................ 238
8 Operation
8-1 Cooling water system with bypass cooling ................................................. 248
8-2 Cooling water system without bypass cooling ............................................ 249
8-3 Cooling water system with circulation ........................................................ 250
8-4 Cylinder lubricant quantity .......................................................................... 274
9 Service during operation
9-1 Location of ball valves - dirty oil samples ................................................... 301
9-2 SAC - clean during operation (example) .................................................... 309
10 Troubleshooting and Special running condition
10-1 Example of inspection point ....................................................................... 341
10-2 Supply unit (example) and example of inspection point ............................. 345
10-3 Leakage on FLV and pipes (example) ....................................................... 351
10-4 Exhaust valve with pressure element ......................................................... 359
10-5 Location of flanges ..................................................................................... 372
10-6 Roller lifting tool assembly .......................................................................... 373
10-7 Pre-tensioner install .................................................................................... 374
10-8 Location of flanges ..................................................................................... 378
10-9 Assembly of roller lifter tool ........................................................................ 379
10-10 Not all turbochargers are defective (example) ........................................... 381
10-11 All turbochargers are defective (example) .................................................. 382
10-12 Exhaust waste gate (example) ................................................................... 385
10-13 WiCE - Gateway Unt (GTU) replacement .................................................. 391
10-14 WiCE - Main Control Unit (MCU) module replacement .............................. 393
10-15 WiCE - Cylinder Control Unit (CCU) module replacement ......................... 395
10-16 WiCE - Angle Control Unit (ACM20) module replacement ......................... 397
10-17 WiCE - Manual Control Panel (MCP) replacement - E26 ........................... 399
10-18 WiCE - Manual Control Panel (MCP) replacement - Back Cover .............. 399
10-19 Turbocharger cut out procedure: Illustration 1 ........................................... 405
10-20 Turbocharger cut out procedure: Illustration 2 ........................................... 406
10-21 Turbocharger cut out procedure: Illustration 3 ........................................... 406
10-22 Turbocharger cut out procedure: Illustration 4 ........................................... 407
X92-B
Operation Manual
Winterthur Gas & Diesel Ltd.
- 15 - Issue 002 2021-11