WinGD X92-B - Troubleshooting and Special running condition

10 Troubleshooting and Special running
condition
10.1 Troubleshooting - general data................................................................................316
10.2 Malfunctions of systems and components...............................................................318
10.3 Failures and defects of UNIC-flex components.......................................................338
10.4 Examine the supply unit for servo oil leakage.........................................................340
10.5 Examine the supply unit for fuel leakage.................................................................344
10.6 Examine the rail unit for leakage.............................................................................348
10.7 Examine the FLV or fuel pipes for fuel leakage.......................................................350
10.8 Temporary cut out a defective injection valve.........................................................354
10.9 Temporary cut out a defective exhaust valve drive.................................................356
10.10 Temporary isolate a cylinder with cooling water leakage........................................358
10.11 Servo oil pump - troubleshooting.............................................................................362
10.12 Servo oil pump - Calibration for Dynex pump..........................................................364
10.13 Servo oil pump - Calibration for Bosch pump..........................................................366
10.14 Servo oil pump - Calibration for Hawe pump...........................................................368
10.15 Fuel pump - cutting out............................................................................................370
10.16 Fuel pump - cutting in..............................................................................................376
10.17 Temporary isolate a defective turbocharger............................................................380
10.18 Temporary isolate the exhaust waste gate..............................................................384
10.19 Isolate a defective engine at twin engine installation...............................................388
10.20 WiCE - Gateway Unit (GTU) replace.......................................................................390
10.21 WiCE - Main Control Unit (MCU) replace................................................................392
10.22 WiCE - Cylinder Control Unit (CCU) module replacement......................................394
10.23 WiCE - Angle Control Unit (ACM20) module replacment........................................396
10.24 WiCE - Manual Control Panel (MCP) replacement.................................................398
10.25 WiCE module - troubleshooting...............................................................................400
10.26 Special running condition: Turbocharger cut out.....................................................402
10.27 Special running condition: Cylinder cut out.............................................................410
X92-B
Operation Manual
Winterthur Gas & Diesel Ltd.
- 315 - Issue 002 2021-11