WinGD X92-B - Page 9

List of tables
1 Introduction
1-1 Change record ............................................................................................. 18
1-2 Data module codes (descriptive data) ......................................................... 24
1-3 Data module codes (procedural data) ......................................................... 26
1-4 List of abbreviations and acronyms ............................................................. 34
4 Design and function of systems
4-1 LP SCR SYSTEM STATUS (MAIN PAGE) ................................................. 101
4-2 LP SCR SYSTEM OVERVIEW ................................................................... 102
4-3 LP SCR INTERFACES ................................................................................ 103
4-4 LP SCR SOFTWARE INFO ........................................................................ 104
4-5 LP SCR PAGE INDEX ................................................................................ 105
4-6 STEAM PRODUCTION CONTROL (SPC) ................................................. 107
5 Design and function of components
5-1 iELBA - control cabinet ................................................................................ 194
5-2 iELBA - error indication ............................................................................... 195
6 Control system
6-1 iELBA Control .............................................................................................. 221
6-2 MAIN ........................................................................................................... 227
6-3 SYSTEM INFO ............................................................................................ 232
6-4 TREND ........................................................................................................ 234
6-5 INSTRUMENTS .......................................................................................... 236
6-6 FUEL / LUBRICATION SYSTEM ................................................................ 239
10 Troubleshooting and Special running condition
10-1 Supply pressure of the cylinder cooling water is too low ............................. 321
10-2 Supply temperature of the cylinder cooling water is too low ....................... 321
10-3 Cylinder cooling water temperature downstream of a cylinder is too high .. 321
10-4 Supply pressure of the cooling water to the SAC is too low ........................ 321
10-5 Supply temperature of the cooling water to the SAC is too low .................. 322
10-6 Temperature of the cooling water downstream of the SAC is too high ....... 322
10-7 Lubricating oil supply pressure at the engine inlet is too low ...................... 323
10-8 Lubricating oil supply pressure upstream of the injectors is too low ........... 323
10-9 Lubricating oil supply temperature at the engine inlet is too high ................ 323
10-10 Lubricating oil supply pressure upstream of the crossheads is too low ...... 323
10-11 Servo oil pressure in the distributor pipe (mini rail) is not in the permitted
range ..........................................................................................................
323
10-12 Servo oil leakage flow from the servo oil supply unit is too high ................. 324
10-13 Servo oil flow at a servo oil pump inlet is too low ........................................ 324
10-14 Bearing oil temperature at a bearing outlet is too high ................................ 324
10-15 Oil mist concentration is too high ................................................................ 324
X92-B
Operation Manual
Winterthur Gas & Diesel Ltd.
- 9 - Issue 002 2021-11