Wolf COB - Fault

65
3062547_201802
Connectiontoamoisture-resistantbalancedue
chimneytypeC43x
Horizontal balanced ues must notbemorethan3mlong
whenconnectingthesystemtoabalanceduechimney.
The balanced ue chimney must be CE-designated.
Connectiontomoisture-resistanceB23uesystemsfor
openueoperation
The horizontal ue must notbelongerthan3m. The ue gas
chimney must be CE-designated.
The horizontal ue must notbelongerthan3m. For horizontal
air supply pipes, a maximum length of 3 m is recommended.
Observe special requirements for ues that are not surrounded
by combustion air in accordance with locally applicable
combustion regulations.
Connectiontomoisture-resistantue,typeC53,C83x,for
roomsealedoperation
Connection to a combustion air and ue system type
C63xthatisnottestedtogetherwiththeoilcombustion
equipment
Original Wolf components are designed for long-term use and
are matched for use with Wolf oil condensing boilers. When
using CE-designated third party equipment, the installer is
responsible for the correct sizing and perfect function of such
systems. Faults, material losses and injuries resulting from
incorrect pipe lengths, excessive pressure drop, premature
wear with escaping ue gas and condensate or incorrect
function, e.g. through components working themselves loose,
are excluded from our warranty if third party equipment that is
only CE/DIBT certied is used.
Horizontal balanced ues must be no longer than 3 m, when
connecting the system to a combustion air supply and a
separate ue.
If the combustion air is drawn from the duct, the duct must be
free from contamination.
Connectiontomoisture-resistanceB33uesystemsfor
openueoperation
Horizontal balanced ues must not be more than 3 m long
when connecting the system to a ue gas chimney.
The ue gas chimney must be CE-designated.
If necessary, obtain the connection piece from the chimney
manufacturer.
The air apertures to the boiler room must be completely free
from obstruction..
Connectiontomoisture-resistantuewithtwoormultipledraughtchimneys(duct)
The requirements of DIN 18160-1 supplementary sheet 3 apply.
Notify your local ue gas inspector prior to installation.
Open ue operation only
Stainless steel duct cover
from the Wolf product
range
Polypropylene system up to
120°C, CE approved
chimney
T400
Open ue and room sealed operation
Duct cover from
the Wolf product
range
chimney
T400
Polypropylene system up to
120°C, CE approved
36 Technicalinformation