WTC 200 - Last Digit; 14 Communication; RS232 Port

22
 The set tare value is displayed with minus sign, Net symbol is shown
in the upper-left corner of the screen.
The tare value acquired from the weighing device memory
is not remembered upon the weighing device restart.
13.8. Last Digit
Function designed to disable display of the last weighing indication digit,
this results with less accurate measurement.
Procedure:
 Enter <P2.rEAd / 2.8.LdiG> submenu.
 Press key, available values are displayed successively one by one:
ALAS
Select to make the last digit always on.
nEur
Select to make the last digit always off.
uuSt
Select to make the last digit on only when the weighing indication is stable.
 Press key to confirm, next go to the home screen.
14. COMMUNICATION
Communication between the scale and the peripheral devices is established
via the following ports: RS232, USB type A, USB type B, wireless
communication (option). To set the ports go to <P4.Conn> submenu.
14.1. RS232 Port
 Enter <P4.Conn / 4.1.rS1> submenu and set respective transmission
parameters:
4.1.1.bAd
Baud rate: 2400, 4800, 9600, 19200, 38400, 57600, 115200 bit/s.
4.1.2.PAr
Parity: nonE – none; EuEn – even; Odd – odd.
 Press key to confirm, next go to the home screen.