5. UNPACKING AND INSTALLATION
Unpack the device and place it on a flat and even surface. Keep it far
away from any sources of heat.
Install the weighing pan and the draft shield, follow figure 4.
Figure 4. Scale assembly
6. START-UP AND OPERATION
6.1. Levelling
To level the weighing instrument turn its feet. Keep turning the feet until the air
bubble takes central position:
6.2. Connecting the Scale to the Mains
The weighing device can be connected to the mains only with a power supply
that comes standard with the particular model. Nominal voltage of the power
supply (specified on the power supply data plate) has to be compatible with
the mains nominal voltage.
To Next Page
Loading...