In order to print the report once again press key.
To exit "report printout mode" press key. As a result home screen
of <Add> working mode is displayed and all the data get zeroed
automatically.
If the display capacity is exceeded (i.e. there is not enough
space for all the digits of the weighing result) <Hi> error
is displayed. In such a case either remove the ingredient
from a weighing pan and finish the totalizing process
or place load of a lower weight value on the weighing pan.
26. WORKING MODE – ANIMAL WEIGHING
Animal Weighing is a working mode enabling you to weigh products that disrupt
efficient establishing of stability. It is mostly intended to measure weight
of animals.
26.1. Local Settings
To go to local settings enter <3.7.AnLS> submenu.
Working mode accessibility
For detailed description read section 19.2.1.
Enter this parameter to declare duration of the
process in seconds (5s, 10s, 20s, 30s, 40s, 50s,
60s) - on the basis of indications recorded within
the set time interval the scale calculates the
weighing result, i.e. an average weight value.
For detailed description read section 19.2.4.
26.2. Animal Weighing Operation
Enter <AnLS> working mode (Animal Weighing).
First text <tinnE> is displayed for 1 s, next, window for setting duration
(in seconds) of animal weighing.
Press key, parameter values are displayed successively one by one:
5[s], 10[s], 20[s], 30[s], 40[s], 50[s], 60[s].
Set the respective value, press key to confirm, weighing window with
A letter is displayed.
Load the weighing pan with an animal.
To Next Page
Loading...