wtw pH/Cond 3320 - Erasing the Measurement Data Memory; Measurement Dataset; Memory Locations

pH/Cond 3320 Data memory
ba77054e03 03/2018 71
options:
 Switch directly to the measured value display with <M>.
 Quit the display and move to the next higher menu level with <F1>/[Back].
10.3.2 Erasing the measurement data memory
Erasing the measurement data memory (see section 10.3.1 E
DITING THE
MEASUREMENT DATA MEMORY, page 69).
10.3.3 Measurement dataset
A complete dataset consists of:
 ID number
 Date/time
 Measured values of the connected sensors
 Measured temperature value of the connected sensors or manually set tem-
perature
 AutoRead info: The AR indicator appears with the measured value if the
AutoRead criterion was met while storing (stable measured value). Other-
wise, there is no AR indicator.
 Calibration evaluation: +++, ++, +, -, or no evaluation
10.3.4 Memory locations
The pH/Cond 3320 meter has two measurement data memories. The
measured values recorded either manually or automatic are stored separately
in individual measurement data memories.
Data memory Maximum number of datasets
Manual data storage 500
Automatic data storage 5000