Xantrex Freedom X 2000 User Manual

Basic Installation Procedures
20 Freedom X 2000 - 230V Owner's Guide
Step 3: Mounting the Unit
To mount the Freedom X:
1. Remove the Freedom X from its shipping container, verify
that all components are present, and record relevant product
information on “Information About Your System” in the
Owner’s Guide.
2. Select an appropriate mounting location and orientation (see
Figure 7 ). To meet regulatory requirements, for use in on-
land applications, the Freedom X must be mounted in one of
the following orientations:
a. Under a horizontal surface (see A)
b. In a horizontal position on a vertical surface (see B)
NOTE: For marine installations, only this orientation is
allowed, due to the probability of moisture finding
access into the enclosure.
c. On a horizontal surface (see C)
Figure 7 Approved Mounting Orientations
A
B
C
3. Mark the desired number of mounting holes on the wall by
placing the unit on the wall.
4. Pilot-drill the mounting holes.
5. Fasten the Freedom X to the mounting surface. If you are
mounting the unit on a wall or bulkhead, use #12 (5.5mm) or
#14 (6.5mm) pan-head wood or sheet metal screws to
secure it to the framing behind the wall or bulkhead.
Alternatively, use nut inserts and the equivalent of M6
machine screws.

Xantrex Freedom X 2000 Specifications

General

Continuous Power	2000W
Surge Power	4000W
Input Voltage	12V DC
Output Voltage	120V AC
Output Frequency	60 Hz
Efficiency	90%
Waveform	Pure Sine Wave
Protections	Overload, Over Temperature, Short Circuit