Pre-service Checklist
62 Freedom X 2000 - 230V Owner's Guide
Pre-service Checklist
WARNING
ELECTRICAL SHOCK HAZARD
Do not disassemble the Freedom X. It does not contain any user-
serviceable parts. Attempting to service the unit yourself could
result in an electrical shock or burn.
Failure to follow these instructions can result in death, serious
injury, or equipment damage.
NOTE: To obtain service go to Contact Information on page ii.
Prior to obtaining service, see below:
1. Check for any error codes displayed on the LCD screen. If a
message is displayed, record it before doing anything
further.
2. As soon as possible, record the conditions at the time the
problem occurred so you can provide details when you
contact customer service for help. Include the following
information:
n What loads the Freedom X was running or attempting
to run
n What the battery condition was at the time (voltage,
etc.) if known
n Recent sequence of events
n Any known unusual AC mains power factors such as
low voltage, unstable generator output, etc.
n Whether any extreme ambient conditions existed at
the time (temperature, vibrations, moisture, etc.)
3. If your Freedom X is not displaying an error code, check the
following to make sure the present state of the installation
allows proper operation:
n Is the inverter located in a clean, dry, adequately
ventilated place?
n Are the battery cables adequately sized as
recommended in the Installation guide?
n Is the battery in good condition?
n Are all DC connections tight?
n Are the AC input and output connections and wiring in
good condition?
n Are the configuration settings correct for your particular
installation?
n Are all disconnects and AC breakers closed and
operable?
n Have any of the fuses blown in the installation?
4. Contact customer support for further assistance. Please be
prepared to describe details of your system installation and
to provide the model and serial number of the unit.
To Next Page
Loading...
Need help?
General
