QMS 3825/3225/2025 User's G uideC-16
Sessions
Purpose: Specify the argument of the %%Session command.
Default: none (job does not consist of subjobs)
Range:
■ 0
length
Specifies the byte count for the end of subjob.
The maximum possible value is 2147483647. A
length of 0 means ignore the byte count termi-
nator. The
length
excludes the %%Session
command
■ 2
delimiter string
Specifies the host-supplied
delimiter string
for
the subjob boundary.
■ 4
delimiter string
Specifies the host-supplied delimiter string for
the subjob boundary. After detection of the
string, all characters up to the next occurrence
of a terminator, or up to 256 characters for the
line, are absorbed.
» Note: The de limiter s tring mus t consist of
printable AS CII characters. It may not contai n
ASCII spaces, ca rriage return, or l ine fe ed. A
delim iter of null means ignore the de limiter
string te rminator. The maxim um value of the
delim iter s tring i s 32 bytes or characters.
Notes: ■ End by Count
You can specify how many bytes are contained in the
current subjob. After the printer reads the required
number of bytes within the current document, the
printer knows that it has reached the end of the sub-
job. Any data which comes after this point, within the
same connection, is treated as the beginning of the
next subjob.
■ End by Delimiter String
You can specify a delimiter string to detect the end of a
subjob. Make sure that the specified delimiter string
does not exist in the actual content of the subjob,
however, because it will end the subjob and treat all
remaining data as a new subjob.
To Next Page
Loading...
Need help?
General
