Sessions
C-21
Doc um e nt Option Co m m an ds
Document Finishing Command
Function: Used when a document has more than one subjob and you
want to control whether different subjobs have the same
format.
The %%IncludeFeature:newlayout command is used at
the beginning of subjobs to do one or both of the following:
■ Indicate to the printer that new document formatting
options, such as grids, booklets, borders, margins,
pages sizes, page offsets, and orientation, should
apply from this point on.
■ Indicate that a new collation range is to take effect
from this point on. This command is intended for use
when multiple small documents are combined into a
single print job in order to control which QMS format-
ting or finishing command settings may be changed
and when they take effect.
Syntax: %%IncludeFeature:newlayout(
value
)
Parameter:
value
Default: n/a
Range: off, on, collate, on collate
off
Ignores any changes to layout or collation properties
specified at this subjob boundary via DOC. The layout and
collation properties in effect with the previous subjob remain
in effect. This command is equivalent to the absence of the
%%IncludeFeature: newlayout command altogether.
To Next Page
Loading...
Need help?
General