QMS 3825/3225/2025 User's G uideC-22
Sessions
on
Any QMS DOC settings for standard commands (such as
layout, document finishing, or document formatting) which
are specified in the current subjob will replace the previous
values of these settings inherited from the previous
subjobs. All other settings inherited from the previous
subjobs in the document remain unchanged. This subjob
will be considered part of the collation range established by
the previous subjob. See the “Collation Range” definition
earlier in this section.
collate
Create a new collation range, but retain the same layout
and document formatting options that were in effect with the
prior subjob, as in the following two subjob sessions:
Subjob A
%!
%%IncludeFeature:numcopies(10)
...
PCL 5 Data
...
Subjob B
%!
%%IncludeFeature:newlayout(collate)
%%IncludeFeature:numcopies(25)
...
PostScript Data
In this example, all of subjob A prints with its attributes
(numcopies and other layout, document format, and
document finishing commands). When that job is
completed, subjob B prints 25 copies with all other attributes
unchanged).
To Next Page
Loading...
Need help?
General