PPRROOBBAABBLLEE CCAAUUSSEESS SSOOLLUUTTIIOONNSS
Application and print driver have conflicting tray
selections.
For details, see Document Prints from Wrong Tray.
An Imaging Security mark has been detected. The Imaging Security feature is enabled, and a security
document has been detected and deleted. For
information about the Imaging Security feature
settings, contact your system administrator or refer to
the System Administrator Guide at www.xerox.com/
office/ALC81XXdocs.
DOCUMENT PRINTS FROM WRONG TRAY
PPRROOBBAABBLLEE CCAAUUSSEESS SSOOLLUUTTIIOONNSS
Application and print driver have conflicting tray
selections.
1 Check the tray selected in the print driver.
2 Access the page setup or printer settings of the
application from which you are printing.
3 Set the paper source to match the tray selected in
the print driver or set the paper source to
AAuuttoommaattiiccaallllyy SSeelleecctt.
4 Check that you have the latest print driver installed.
For details, go to www.xerox.com/office/
ALC81XXsupport.
Note: To have the print driver select the tray, set
the tray used as the paper source to AAuuttoo
SSeelleeccttiioonn EEnnaabblleedd.
PRINTER IS MAKING UNUSUAL NOISES
PPRROOBBAABBLLEE CCAAUUSSEESS SSOOLLUUTTIIOONNSS
One of the trays is not installed correctly. Open and close the tray from which you are printing.
There is an obstruction or debris inside the printer. Power off the printer and remove the obstruction or
debris. If you cannot remove the obstruction, contact
your Xerox
®
service representative.
The printer beeps at each touch on the control panel. Check the Alerts setting. For details, refer to the System
Administrator Guide at www.xerox.com/office/
ALC81XXdocs.
Xerox
®
AltaLink
®
C8130/C8135/C8145/C8155/C8170 Series Color Multifunction Printer User Guide 291
Troubleshooting
To Next Page
Loading...
Need help?
General
