Selecting a location for the printer
• Leave enough room to open trays, covers, and doors and to install hardware options.
• Set up the printer near an electrical outlet.
CAUTION—POTENTIAL INJURY: To avoid the risk of fire or electrical shock, connect the
power cord to an appropriately rated and properly grounded electrical outlet that is near
the product and easily accessible.
CAUTION—SHOCK HAZARD: To avoid the risk of electrical shock, do not place or use this
product near water or wet locations.
• Make sure that airflow in the room meets the latest revision of the ASHRAE 62 standard or the
CEN Technical Committee 156 standard.
• Provide a flat, sturdy, and stable surface.
• Keep the printer:
– Clean, dry, and free of dust
– Away from stray staples and paper clips
– Away from the direct airflow of air conditioners, heaters, or ventilators
– Free from direct sunlight and humidity extremes
• Observe the recommended temperatures and avoid fluctuations.
– Ambient temperature: 10 to 32.2°C (50 to 90°F)
– Storage temperature: -40 to 40°C (-40 to 104°F)
• Allow the following recommended amount of space around the printer for proper ventilation:
1. Top: 305 mm (12 in.)
2. Rear: 100 mm (3.94 in.)
3. Right side: 76.2 mm (3 in.)
4. Front: 305 mm (12 in.)
The minimum space needed in front of
the printer is 76 mm (3 in.).
5. Left side: 110 mm (4.33 in.)
28
Xerox
®
B310 Printer
User Guide
Set up, Install, and Configure
To Next Page
Loading...
