6. If fault persists, repeat the previous steps; if fault persists after that, call for service.
013-106
Cause: Jam/fault with the SquareFold Trimmer Module
Remedy: Perform the following:
1. Open the Top Left and Right Covers of the SquareFold Trimmer Module.
2. Carefully remove all sheets and paper scraps from jam clearance areas.
3. Close the SquareFold Trimmer Module Top Left and Right Covers.
4. Check the Trimmer Waste Container:
• If full, empty the container and reinsert it in the SquareFold Trimmer Module.
• If the container is partially pulled out, push it completely in.
5. If necessary, follow any remaining instructions on the machine’s UI.
6. If fault persists, repeat the previous steps; if fault persists after that, call for service.
013-208
Cause: The Trimmer Waste Container is full or has a fault
Remedy: Perform the following:
1. Pull open the container and empty any trimmer scraps from it.
2. Reinsert the container into the SquareFold Trimmer Module.
3. Ensure that the container is fully pushed in, and that the indicator light is not lit.
4. If fault persists, repeat the previous steps.
5. If fault persists, power off/on the machine.
6. If fault persists, call for service.
013-221
Cause: Jam or communication error with the SquareFold Trimmer Module
Remedy: Perform the following:
1. Power off/on the machine.
2. If fault persists, call for service.
013-222
Cause: Jam or communication error with the SquareFold Trimmer Module
Remedy: Perform the following:
1. Power off/on the machine.
2. If fault persists, call for service.
013-223
Cause: Jam or communication error with the SquareFold Trimmer Module
Remedy: Perform the following:
1. Power off/on the machine.
23-19Xerox
®
D95/D110/D125/D136 Copier/Printer
User Guide
SquareFold Trimmer Module
To Next Page
Loading...
Need help?
General
