Xerox D136 User Manual

Cause and RemedyFault code
Cause: Delayed Print documents cannot be registered because of hard disk
malfunction.
Remedy: Contact the Customer Support Center.
016-710
Cause: The configured maximum e-mail size has been exceeded.
Remedy: Take one of the following actions and resend the e-mail:
• Decrease document pages
• Reduce the Scan Resolution
• Reduce the Scan Magnification
• Have the system administrator increase your Maximum Send E-mail Data Size
016-711
Refer to 003-751.016-712
Cause: The password set to the mailbox and the inputted password were not in
agreement.
Remedy: Enter the correct password.
016-713
Cause: Specified mailbox does not exist.
Remedy: Create a mailbox or specify the existing mailbox.
016-714
Cause: Unable to spool TIFF file because of insufficient disk space.
Remedy: Remove unnecessary documents and users stored on the printer and
then attach the hard disk. When attaching a hard disk, contact the Customer
Support Center.
016-716
Cause: PCL print data could not be processed as there was insufficient memory.
Remedy: Reduce resolution, cancel 2 Sided printing or N up, and retry printing.
016-718
Cause: PCL print data could not be processed as there was insufficient memory.
Remedy: Increase the size of the print page buffer.
016-719
Cause: The PCL print data included a command which cannot be processed.
Remedy: Confirm the print data and try to print again.
016-720
Cause: An error occurred during print processing. Probable causes are as follows:
1. Printing was instructed by Automatic Tray Selection when Paper Type Priority
is set to Automatic Tray switching Off for all paper in the Common Settings.
2. ESC/P command error
Remedy: For 1, when printing by Automatic Tray Selection, set one of the paper
types to a setting other than Automatic Tray Switching Off in Paper Type Priority.
For 2, check print data.
Refer to “Paper Type Priority” in the System Administration Guide.
016-721
Cause: Unsupported staple position is specified.
Remedy: Confirm the position, and specify the print data again.
016-722
Cause: Unsupported punch position is specified.
Remedy: Confirm the position, and specify the print data again.
016-723
Cause: An unsupported tag was included in the TIFF file.
Remedy: Check the print data.
016-728
15-19Xerox
®
D95/D110/D125/D136 Copier/Printer
User Guide
Problem solving

Xerox D136 Specifications

General

Brand	Xerox
Model	D136
Category	Copier
Language	English