General Procedures and Information
FaxCentre 2121/2121L 11/06 6-15
Connections
Figure 2
Connecting the telephone line and LAN
• Plug one end of the telephone lead (1) into socket (A) of the machine and the other end into
the telephone wall socket (the types of connector may vary depending on the country).
• If the machine is equipped with a LAN connection (depending on the model), plug one end of
the LAN cable (supplied by your network administrator) into socket (B) of the machine and
the other end into the local area network socket allocated to your fax.
Powering up the machine
WARNING:
Refer to the safety regulations in the Introduction
• Plug one end of the power cord (2) into the power socket (D) of the machine and the other
end into the wall socket (the types of connector may vary depending on the country).
• Set the on/off switch to the <I> position (On). After a few seconds, as soon as the warm-up of
the machine is finished, the date and the time are displayed.
C
B
A
D
2
1
To Next Page
Loading...
