General Procedures and Information
FaxCentre 2121/2121L 11/06 6-39
• Page threshold (T_SEUIL_ OPC): trigger level (expressed as the number of pages remaining
to be printed) for the transmission of a remote readout triggered by the drum threshold crite-
rion, entered by the installer.
• Last remote maintenance (T_DATE_SEUIL_ OPC): date of the last remote readout triggered
by the drum threshold criterion, or installation date if there has not been any previous remote
readout.
• Pages (T_CPT_OPC): number of pages remaining to be printed at the instant of the trigger-
ing of the previous remote readout by the drum threshold criterion (or 0 if there has not been
any previous remote readout).
• Last replacement (T_DATE_CHG_ OPC): date of the last replacement of the drum.
Revision
• Estimated number of pages (T_INIT_FOUR): Number of pages estimated before the next
revision.
• Page threshold (T_SEUIL_ FOUR): entered by the installer, valeur de déclenchement (en
nombre de pages restant à imprimer) pour l'émission d'une télérelève sur critère seuil révi-
sion.
• Last remote maintenance (T_DATE_SEUIL_ FOUR): date of the last remote readout trig-
gered by the drum threshold criterion, or installation date if there has not been any previous
remote readout.
• Pages (T_CPT_FOUR): number of pages remaining to be printed at the instant of the trigger-
ing of the previous remote readout by the drum threshold criterion (or 0 if there has not been
any previous remote readout).
• Last replacement (T_DATE_CHG_ FOUR): date of the last replacement of the drum.
Transmission Data
• Readout reason (TCAUSE_EMIS): reason for the remote readout transmission;
• Readout date (TDATE_EMIS): date of the transmission of the remote readout.
Reminders
• Every machine is equipped with a copy counter, implemented in EEPROM memory on the
CPU board. This counter is used in particular by the Remote Readout function. It can be con-
sulted by the user. This counter cannot be modified. It is stored indefinitely.
• Before any corrective service call on the machine that risks modifying the installation parame-
ters or the value of the counter (replacement of the CPU board or installation of new soft-
ware), a manual Remote Readout transmission should be performed, if the state of the
machine allows it. If this transmission is not possible for any reason, print out the Remote
Readout parameters or display the copy counter and note these values on the service call
report.
To Next Page
Loading...
