General Procedures and Information
FaxCentre 2121/2121L 11/06 6-53
Figure 3
Laser Emission Area
Main scanning direction
• The print start position is determined by the main scanning print start signal (/HSYNC) output
from the CPU and the width of the paper.
• The laser emission area is determined by the paper size. Areas with a width of 4 mm on both
edges are not, however, printed.
Sub-scanning direction
• The print start position is determined by the sub-scanning print start signal (/TOD) output from
the CPU and the length of the paper.
• The laser emission area is determined by the paper size. Areas with a width of 4 mm on both
the leading and trailing edges are not, however, printed.
To Next Page
Loading...
