Service Call Procedures
FaxCentre 2121/2121L 11/06 1-5
3. Clean the rolls of the document feeder and feed shafts, and also the two idler rolls located on
the mobile part of the scanner, with a lint-free cloth moistened with film remover.
Note: To clean them, rotate them in the same direction as during paper transport. The
recommended interval is between 2 to 6 months.
Retard Pad
To clean the retard pad, perform the following:
1. Set the on/off switch to “O” (off).
2. Open the control panel/scanner by pressing the cover release latch located on the left of the
machine.
CAUTION
The opening is limited to approx 60° by stops. Do not try to force the panel any further.
3. Wipe the elements of the retard pad with a lint-free cloth soaked with film remover.
Note: The recommended interval is between 2 to 6 months.
CIS Window
To clean the CIS Window, perform the following:
1. Set the on/off switch to “O” (off).
2. Open the control panel/scanner by pressing the cover release latch located on the left of the
machine.
CAUTION
The opening is limited to approx. 60° by stops: do not try to force the panel any further.
3. Wipe the scanner window with a lint-free cloth moistened with film remover, or with antistatic
paper tissues as used for cleaning optical glass.
Note: The recommended interval is to be defined depending on utilization. After cleaning, it is
advised to make a local copy to check the cleanliness of the window.
To Next Page
Loading...
