Repairs and Adjustments
4-34 11/06 FaxCentre 2121/2121L
4. Lift the control panel at its upper right-hand corner (A), hold it and apply a medium amount of
pressure halfway down its side (B). First free the right-hand side of the control panel by push-
ing downwards (C).
Figure 2
5. Lift the control panel at its upper left-hand corner (D). Hold it and apply a medium amount of
pressure halfway down its side (E), then free the left-hand side of the control panel by push-
ing downwards (F). Disconnect the control panel flat cable and remove the control panel.
6. Disconnect the flat cable of the display, and the loudspeaker connector.
7. Remove the eight mounting screws of the control panel board. Remove the control panel
board, the key pad, the display, the glass and the control panel cover.
Replacement
1. Unpack and visually inspect the new parts.
2. Put the new parts in place on the control panel cover in the following order: glass, display, key
pad then control panel circuit board. Screw in and tighten the eight mounting screws.
3. Connect the connectors of the loudspeaker and of the display.
4. Connect the CIS flat cable to the connector on the control panel board.
B
A
C
F
E
D
To Next Page
Loading...
