Operation
6-15
Assembly
¾ Choose the copy type between ASSEMBLED or NOT ASSEMBLED.
¾ Press OK to confirm.
Origin
Change the orientation of the scanner.
Enter new values of X and Y given in mm (X < 210 and Y < 286) to move the scanning
zone as shown on the figure below:
¾ Select the X and Y coordinates with the
or keys.
¾ Set the required coordinates with the numeric keypad or
or .
¾ Press OK to confirm the settings.
Contrast
¾ Set the desired contrast with or .
¾ Press OK to confirm the settings.
Brightness
¾ Set the desired brightness with or .
¾ Press OK to confirm the settings.
Margins
Shift the side margins of the document to the left or to the right:
¾ Adjust the left / right margins shift (in steps of 0.5 mm) with
or .
¾ Press OK to confirm the settings.
TOP OF SHEET
Scanned area
Top view: scanned side down
END OF SHEET
To Next Page
Loading...
