4-12
Setting the machine
Manual configuration
To configure the machine manually, you should obtain the usual information used to
set a peripheral device (IP address, sub-network mask, network and gateway address).
To configure the local network setting manually:
M 2531 OK - SETUP / NETWORKS / LOCAL NETWORK / CONFIGURATION
¾ Choose MANUAL, and press OK to confirm.
IP address
M 2532 OK - SETUP / NETWORKS / LOCAL NETWORK / IP ADDRESS
¾ Enter the IP address of the machine and press OK to confirm.
Sub-network mask
M 2533 OK - SETUP / NETWORKS / LOCAL NETWORK / SUBNET MASK
¾ Enter the sub-network mask of the machine and press OK to confirm.
Gateway address
M 2534 OK - SETUP / NETWORKS / LOCAL NETWORK / GATEWAY
¾ Enter the IP address of the network gateway and press OK to confirm.
IEEE address (or Ethernet address) or MAC address
M 2535 OK - SETUP / NETWORKS / LOCAL NETWORK / IEEE ADDRESS
The Ethernet card of the machine already has a read-only IEEE address.
Netbios names
These names, which can be used with the network options, are used to identify the
machine from a PC connected to a local network (for instance with the name
"IMP-NETWORK-1").
M 2536 OK - SETUP / NETWORKS / LOCAL NETWORK / NETBIOS 1 NAME
M 2537 OK - SETUP / NETWORKS / LOCAL NETWORK / NETBIOS 2 NAME
¾ Enter the selected name (15 characters max) and press OK to confirm.
The WINS1 and WINS2 servers, used with the network options, allow access to
machines on other sub-networks by means of their NetBIOS name.
To Next Page
Loading...
