Maintenance
7-13
¾ Once the chip card has been read, the display shows:
¾ Remove the card.
CAUTION: If the following message is displayed, check that you have inserted
the chip card the right way up.
Cleaning
Cleaning the printer
Dust, dirt and paper debris can affect printer performance. Clean the printer regularly.
CAUTION: Use a soft cloth to clean the printer. Never use abrasive or corrosive
detergents.
CAUTION: The fusing unit can become very hot during operation. To avoid
injury - do not touch. Wait for at least 10 minutes after the printer has been turned
off and make sure that the fusing unit has cooled down before cleaning the
inside of the printer.
Clean the outside of the printer with a soft cloth.
DRUM OK
REMOVE CARD
CANNOT READ CARD
REMOVE CARD
To Next Page
Loading...
