Setting the machine
4-15
¾ To configure your machine in automatic transmission line selection mode, press
keys M 2611.
¾ To configure your machine in manual transmission line selection mode, press keys
M 2612.
¾ To configure your machine in systematic line 1 (L1)(2121) transmission line
selection mode, press keys M 2613.
¾ To configure your machine in systematic line 2 (L2)(2121L) transmission line
selection mode, press keys M 2614.
Recording the line 2 number (2121L)
On your machine, the fax machine number defined by selecting M 22 in the operator
menu is allocated implicitly to line 1 (L1).
You can record the fax machine number that corresponds to line 2 (L2) on your
machine. This number is sent to the people you call and may also appear on the header
on each page of any documents you send to them.
¾ To record the number of line 2 (L2) on your machine, press keys M 262, then enter
or modify the number.
Note: If the number for line 2 (L2) is not defined, by default it takes the value of
line 1.
Selecting the manual transmission mode line
In manual transmission mode you must always select the line (L1 or L2) to be used. To
do so there is an additional selection possible in the transmission note.
Selecting:>>LINE L1 selects the line to be used for the transmission. Pressing the
and
keys switches the LINE L1 (2121) selection to LINE 2 (2121L) and vice versa.
The additional selection of the line to be used is offered in the following transmission
notes:
• Single or multi-recipient transmission
• Report requested
• Transmission to a mailbox
• Mailbox report
• Re-transmission
Note: The selection of the line to be used in the transmission notes is only
offered if your machine is configured in manual transmission mode. If it is
To Next Page
Loading...
