7-16
Maintenance
Communication error codes
The communication error codes appear in the logs and transmission reports.
General codes
Code 01 - Busy or no fax answer
This code appears after 6 failed attempts. Call later.
Code 03 - User break
A communication has been stopped by the user pressing the
key.
Code 04 - Non programmed number
A number saved as a one-touch key or abbreviated number is not valid (example: a
delayed transmission was programmed with a one-touch key and this key has been
deleted in the meantime).
Code 05 - Scanning default
An incident occurred with the scanner, for example, the sheet is jammed.
Code 06 - Printer default
An incident occurred in the printer: no paper, paper jam, opened cover, etc. In the
reception mode, this incident appears only if the reception setting is switched to
WITHOUT PAPER (refer to Reception without paper on page 4-6).
Code 07 - Disconnected
The line has been cut (bad line). Check the number and try again.
Code 08 - Quality
The document you sent was not received. Contact your subscriber.
Code 0A - No document to be polled
You tried to poll a document from an empty mailbox or the password entered was
incorrect.
To Next Page
Loading...
