Installing your machine
2-9
Installing the original document output tray
¾ Insert the document output tray into the two slots located just below the control panel
on the front of the machine.
Loading paper
¾ Move the paper size guide to one side.
¾ Place a stack of paper into the tray. In case of letterhead paper, be sure to place the
paper printed side up.
¾ Secure the stack of paper by pushing the paper size guides against the right and left
edges of the stack.
Supported types of paper:
Auto-feed cassette 60 to 90 g/m
2
/ 16 to 24 lb
Manual feed tray 60 to 160 g/m
2
/ 16 to 43 lb
To Next Page
Loading...
