General Procedures / Information
FaxCentre F110 12/04 6-9
Note: Should the error message Cannot read card appear on the display, you may have inserted
the Plug ‘n’ Print card incorrectly. The contacts must face to the left as you insert the card into the
machine
10.It may take a moment to update the cartridge. When the process is completed, the following
appears on the display: ACTION COMPLETED / REMOVE CARD
11. Pull the Plug’n’Print card out of the FaxCentre F110. You can interrupt the recharging proc-
ess at any time by simply pressing STOP. However, the toner level memory must be updated
for each new print cartridge. If you have pressed the STOP key by mistake, you can restart
the recharging process as follows:
1 Press MENU/OK, 62 and OK
2 Select new black with the arrows, and confirm with OK. Select yes with arrows and confirm
again. After a short time, the FaxCentre F110 will ask you to insert the Plug’n’Print card.
Note: If the toner level of your cartridge is low, each time you open and close the cover, the
following question will appear on the display: black=new? If you have not installed a new
cartridge, press STOP. If you have installed a new cartridge, press OK and follow the steps
above.
To Next Page
Loading...
Need help?
General
