Xerox Phaser 3320DN User Manual

Setup Options
Xerox Phaser 3320DN/3320DNI
User Guide
85
For more detailed information refer to the Xerox Phaser 3320DN/3320DNI System Administrator
Guide.
Option Description
Settings
* denotes factory default
TCP/IP(IPv4) Selects the appropriate protocol and
configures parameters to use the network
environment.
Note: There are lots of parameters to be
set. If you are not sure, leave as is, or
consult the network administrator.
•DHCP*
• BOOTP
•Static
TCP/IP(IPv6) Selects this option to use the network
through IPv6.
IPv6 Activate:
•On*/ Off
DHCPV6 Config:
• Router*
• DHCPv6 Address
• DHCPv6 Off
Ethernet Speed Configure the network transmission speed.
•Auto*
• 10M Half
• 10M Full
• 100M Half
• 100M Full
•Giga Full
802.1x Use to enable 802.1x and CentreWare
Internet Services.
Off* / On:
•EAP-MD5
• EAP-MSCHAPv2
•PEAP
•EAP-TLS
Wireless (Phaser
3320DNI only)
Use to enable the machine to be
configured on a wireless network
connection.
Note: If you choose a wireless connection
for your printer, you cannot use a wired
connection at the same time.
Wi-Fi:
•On / Off
WPS Setting:
•PBC*
•PIN
WLAN Default:
•Restore
WLAN Signal:
• Excellent
• Very Good
• Good
•Low
• Very Low
•No Signal
Clear Setting Reverts the network settings to the default
values.
• Clear? Yes / No
Network Conf. Enables printing of the Network
Configuration report.
•Print? Yes / No

Xerox Phaser 3320DN Specifications

General

Brand	Xerox
Model	Phaser 3320DN
Category	Printer
Language	English