Troubleshooting
Xerox Phaser 3320DN/3320DNI
User Guide
98
Bypass Tray
1. If the paper is not feeding properly, pull the paper out of
the machine.
2. Press the release latch on the left side of the machine
and open then close the front door.
3. Re-load the bypass tray to resume printing.
Inside the Machine
CAUTION: The fuser area is hot. Take care when removing paper from the machine.
1. Press the release latch on the left side of the machine.
2. Open the front door.
3. Pull the print cartridge out, lifting it up slightly at the
front.
To Next Page
Loading...
