User Safety Summary152
The power cord is attached to the printer as a plug-in device at the back of the
printer. If it is necessary to disconnect all electrical power from the printer,
disconnect the power cord from the electrical outlet.
WARNING!
Do not remove the covers or guards that are fastened with screws unless you
are installing optional equipment and are specifically instructed to do so.
Power should be OFF when performing these installations. Except for user-
installable options, there are no parts that you can maintain or service behind
these covers.
" Leave the printer on for optimum performance; it does not pose a
safety hazard.
The following are hazards to your safety:
The power cord is damaged or frayed.
Liquid is spilled into the printer.
The printer is exposed to water.
If any of these conditions occur, do the following:
1 Turn off the printer immediately.
2 Disconnect the power cord from the electrical outlet.
3 Call an authorized service representative.
Laser Safety
With specific regard to lasers, this printer complies with laser product
performance standards set by governmental, national, and international
agencies and is certified as a Class 1 Laser Product. The printer does not
emit hazardous light because the beam is totally enclosed during all modes of
customer operation and maintenance.
Maintenance Safety
Do not attempt any maintenance procedure that is not specifically
described in the documentation supplied with your printer.
Do not use aerosol cleaners. The use of supplies that are not approved
may cause poor performance and could create a hazardous condition.
Do not burn any consumables or routine maintenance items. For
information on Xerox supplies recycling programs, go to
www.xerox.com/
gwa.
To Next Page
Loading...
